
Leaking Tap Repairs Rowville
A tap that drips all night, a mixer that leaks from under the handle or a shower that will not quite turn off? We repair and replace taps across Rowville, usually in one visit. Ring 03 9088 0246.
- Licensed and insured
- Based in Rowville 3178
- Cost agreed before work
- Urgent call-outs
Why a dripping tap is worth fixing
A single dripping tap can waste thousands of litres a year. A dripping hot tap adds heating cost on top, for water that is never used. Drips also leave mineral stains on basins and sinks, and a leak from the tap body or base can soak into a vanity or benchtop and cause swelling and mould.
Most tap leaks are quick to repair, and fixing them early often means a simple part replacement rather than a new tap.
Types of taps in Rowville homes
Homes built in Rowville through the eighties and nineties commonly had separate hot and cold taps with jumper valves or ceramic disc spindles. Many have since been updated with single-lever mixers in kitchens, bathrooms and laundries. Shower taps may be separate taps or a wall mixer. We repair all of these.
Jumper valve taps
Older-style taps with a rubber washer on a jumper valve. When the washer wears or the seat beneath it is pitted, the tap drips. We replace the washer and jumper, and reface or reseat the tap body if needed.
Ceramic disc taps
Quarter-turn taps with ceramic discs that slide over each other. When the discs chip or the seals wear, the tap drips or will not turn off fully. We replace the cartridge.
Mixer taps
Single-lever mixers use a cartridge that controls flow and temperature. Worn cartridges cause dripping, stiffness, difficulty adjusting temperature or water leaking from under the handle. We replace the cartridge with the correct part for your mixer. If parts are not available or the tap is badly worn, we can supply and fit a new mixer.
Shower mixers and taps
A dripping showerhead usually means a worn washer, disc or cartridge in the shower tap or mixer. Because shower mixers sit inside the wall, a leak behind the tiles can also cause hidden water damage. We repair the mixer from the front where possible, and check for signs of leaks behind the wall.
Garden taps
Garden taps suffer from weather, hoses being pulled on and occasional frost. Common problems are dripping spouts, leaks from the spindle and cracked tap bodies. We repair or replace garden taps and can fit vacuum breakers where required.
Signs your tap needs attention
- Dripping from the spout after the tap is turned off
- Water leaking from under the handle or around the base
- A tap that is stiff, loose or hard to turn
- A mixer that is hard to set to the right temperature
- Banging pipes when the tap is turned off quickly, which may point to high pressure
- Water pooling in the vanity cupboard or under the sink
What we do
- We identify the tap type and the cause of the leak.
- We explain the fix and the cost before starting.
- We isolate the water and dismantle the tap.
- We replace worn parts such as washers, jumpers, cartridges, O-rings and seals.
- We reassemble and test the tap, checking for drips and smooth operation.
- We check nearby connections, including flexible hoses under the sink or vanity.
We carry common washers, cartridges and spindles in the van, so most leaking taps are fixed on the first visit.
When to replace a tap
Sometimes replacement is the better option, such as when:
- Parts are no longer available for an older mixer
- The tap body is cracked or badly corroded
- The tap has been repaired several times and keeps failing
- You want an updated look or a more water-efficient model
We can supply and fit a new tap, or install one you have chosen, provided it is WaterMark certified.
Flexible hoses under the sink
When we repair a tap, we also check the braided flexible hoses that connect it to the pipes. If they are rusty, frayed or bulging, we will recommend replacing them before they burst. See our guide on braided flexible hoses.
High water pressure
If taps in your home wear out quickly, or the pipes bang when a tap is turned off, high mains pressure may be a factor. Parts of Rowville can have high pressure, and it shortens the life of taps, hoses and valves. We can test your pressure and fit a pressure limiting valve if needed. See water pressure problems.
Tap repairs in nearby suburbs
We repair leaking taps throughout Rowville, Lysterfield, Scoresby, Knoxfield, Ferntree Gully, Wheelers Hill, Mulgrave, Dandenong North and Endeavour Hills.
What you get with dripping taps and mixers
- Diagnosis
- We trace the fault with the right gear (camera, locator, thermal imager, gauge) and show you what we found
- Your price
- Talked through on site before we start, and set out in writing for larger work
- Who does it
- A Victorian licensed plumber, insured, with the licence class the job calls for
- Parts
- WaterMark approved fittings and fixtures, fitted to the Australian Standards
- Records
- A compliance certificate where the law needs one, and before and after photos on request
- Finish
- Repair tested in front of you, floors and benches wiped down, old parts gone with us
Dripping Taps and Mixers in Rowville: your questions
Why does my tap keep dripping after I replaced the washer?
If the seat in the tap body is pitted, even a fresh washer has nothing smooth to close against. Reseating or refacing the tap usually fixes it.
Can you repair my mixer tap?
In most cases, yes, by replacing the cartridge. If parts are unavailable, we can supply and fit a new mixer.
Why is water leaking from under my tap handle?
Worn O-rings or a failed cartridge are the usual causes. Both can be replaced.
How much water does a dripping tap waste?
It depends on the drip rate, but a steady drip can waste thousands of litres a year.
Can you install a tap I bought myself?
Yes, as long as it is WaterMark certified and suitable for your sink or basin.
My shower drips after I turn it off. Is that a tap problem?
Usually, yes. A worn washer, disc or cartridge in the shower tap or mixer is the most likely cause.
Before you call, read this
Send us the details
Tell us about the job and a licensed Rowville plumber will ring you back. For a flood, a burst pipe or an overflowing sewer, skip the form and ring 03 9088 0246.
We do not publish a price list, because no two jobs are the same. You will know the cost before any work begins.
How a Rowville Plumbing job works
- Step 1Tell us the problem
Ring or send the form with what has gone wrong and where. A photo of the leak, the drain or the hot water label means we turn up with the right parts.
- Step 2Diagnosis and price
We track down the cause, show you what we found and give you the cost. Nothing gets pulled apart until you say go.
- Step 3Repair and test
The work is done to the Victorian plumbing rules and Australian Standards, then tested in front of you. Regulated work gets a compliance certificate.
- Step 4Clean up and check in
Floors and benches are left as we found them, old parts leave with us, and on bigger jobs we ring a few days later to make sure all is well.
Other plumbing work we do in Rowville
- Urgent Plumbing Call-Outs
- Blocked Drain Clearing
- Hot Water Fault Finding
- New Hot Water Systems
- Heat Pump Installation
- Burst and Split Pipes
- Toilet Fixes and New Suites
- Blocked Toilet or Sink
- Hidden Leak Detection
- CCTV Drain Inspection and Relining
- Stormwater Pits and Drains
- Low or High Water Pressure
- Ensuite and Bathroom Renovations
- Gutter and Downpipe Replacement
Rowville, Stud Park and the suburbs around Lysterfield
We are based in Rowville, between EastLink and the Lysterfield hills, so most jobs are a few minutes from Stud Park. From here it is a quick run up Stud Road to Knoxfield and Scoresby, east to Lysterfield and Ferntree Gully, across Wellington Road to Wheelers Hill and Mulgrave, and south over Police Road to Dandenong North and Endeavour Hills. Somewhere else nearby? Ring 03 9088 0246 and ask.
Plumbing problem in Rowville?
Talk to a licensed local plumber today. You will know what is wrong and what it costs before we start.